web analytics

Which two commands verify the model and serial number of a controller?

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two) A. show sysinfo B. show udi

Which troubleshooting methodology does this action demonstrate?

An engineer has received an alarm on a wireless LAN controller and is unsure of its meaning. The engineer attempted to ping the wireless LAN controller interfaces. Which troubleshooting methodology

Which field contacts the IP address offered to the client?

An engineer has run the debug dhcp packet enable command on the wireless LAN controller CLI. Which field contacts the IP address offered to the client? A. siaddr B. ciaddr

Which starting prefix debug command can help determine a combination of discovery/join and DHCP process status?

A Cisco WLC v7.0 is not seeing an AP join. Which starting prefix debug command can help determine a combination of discovery/join and DHCP process status? A. debug capwap events

Which troubleshooting methodology can be used to begin the troubleshooting process?

An alarm is reporting that one of four ports of a lag group have gone down on a wireless LAN controller. Which troubleshooting methodology can be used to begin the

Which change resolves the roaming delays?

A network engineer has identified clients who are experiencing delays white roaming. The network is configured with WPA2-Enterpnse. AES encryption, 802 1X authentication, and Cisco Centralized Key Management Which change

Which configuration is causing the failure?

An engineer has configured 802 1x for the network and all but one of the APs are passing authentication. Which configuration is causing the failure? A. The AP has override

Which feature should a network engineer enable within a mixed-client network to ensure that the legacy client operates at the best possible rates?

Which feature should a network engineer enable within a mixed-client network to ensure that the legacy client operates at the best possible rates? A. ClientLink B. RRM C. DCA D.

Which two methods will allow you to access the standby unit?

You have successfully configured HA and SSO using two Cisco 5508 Wireless LAN Controllers. You are able to access the Active Primary WLC but are unable to access the Secondary

Which guideline must the engineer follow?

An engineer is concerned about rogue-on-wire and wants to enable port security. Which guideline must the engineer follow? A. Configure Switched Port Analyzer destination ports as secure. B. Use 802

Which technique must the engineer consider legal ramifications?

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications? A. rogue AP containment B. RF detection

Which encryption type between the access point and the mass LAW controller?

In a cisco OfficeExtend environment, which encryption type between the access point and the mass LAW controller? A. DTLS B. TIS C. STIS D. OpenSSL Correct Answer: A

Which configuration meets this requirement?

An engineer is deploying a wireless infrastructure and must use Layer 2 discovery for access point association. Which configuration meets this requirement? A. Configure the Access Points and WLC management

Which action will resolve the issue?

A wireless engineer has completed the configuration of a new WLAN on the existing Cisco wireless infrastructure. During testing he found that the wireless client’s authenticate and received the correct

Which action will improve client connections in building B?

A company consists of two adjacent buildings, each with its own Cisco 5508 Wireless Controller with APs joined to the controller in the building. The two controllers are configured identically

Which change m the DTPC transmit power threshold must be made to allow APs to globally increase AP transmit power by 3dBm?

A WLAN was installed at a high AP density. DTPC is lowering the transmit power of many APs too low. Which change m the DTPC transmit power threshold must be

Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages?

Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages? A. debug pm pki enable B. debug cert events enable C.

Which two issues can cause this problem?

Clients are failing EAP authentication A debug shows that an EAP handshake started and the clients are then de-authenticated. Which two issues can cause this problem’? (Choose two.) A. The

Which ports require unrestricted port access for CleanAir RF spectrum analysis between the AP and Cisco Spectrum Expert?

Which ports require unrestricted port access for CleanAir RF spectrum analysis between the AP and Cisco Spectrum Expert? A. UDP 5246 and 5247 B. UDP 37540 and 37550 C. TCP

Which action must be taken to resolve the issue?

A wireless engineer is unable to join lightweight access points to the Cisco Wireless Controller. The access points receive ip addresses from a DHCP pool configured on the core switch.

When the workstation moves, it loses connectivity and disrupts operation. What can the engineer implement to minimize roaming problems?

A mobile workstation in a factory contains an AP that is configured as a workgroup bridge. When the workstation moves, it loses connectivity and disrupts operation. What can the engineer

Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure?

Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure? B. The smaller the circle, the more localized the impact is. A. The

What two conditions must occur for the controller to dynamically mitigate the situation?

A WLC receives a coverage hole detection alert from an AP. What two conditions must occur for the controller to dynamically mitigate the situation? (Choose two.) A. The AP serving

What configuration task will fix this issue

Two 5508 Wireless Lan Controllers are managing all Access Points throughout the network The WLCs are located in different locations to provide geographical redundancy A Mobility Group has been configured

What effect will this have in the APs?

A WLAN engineer has just completed a wireless network installation using Cisco 2700 series access points. After checking the WLC, it seems that the APs are running in medium power.

Which two commands should be used to resolve the issue?

A network engineer is troubleshooting why EAP authentication with a client is failing. Which two commands should be used to resolve the issue? (Choose two) A. debug dot1x notifications enable

Which combination determines the resulting primary 40 MHz and primary 80 MHZ channels?

A Wireless LAN Cisco engineer is troubleshooting 802. 11ac WLAN at customer site Doe to interferences with neighboring 802 11n networks the engineer must determine the current primary secondary channel

Which two conditions are possible when adding a custom rule to a controller?

An engineer is creating a custom rogue classification rule directly on a controller. Which two conditions are possible when adding a custom rule to a controller? (Choose two.) A. internal

Which action must be taken for the AP to associate with the controller?

A recently acquired Cisco Aironet 1550 series AP is unable to join the WLC. This message is observed on the AP console: AAA Authentication Failure for UserName:CC93.1981.0035 User Type: WLAN