web analytics

What is the next thing that should be checked?

When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful. What is the next

Which IPsec mode will encrypt a GRE tunnel to provide multiprotocol support and reduced overhead?

Which IPsec mode will encrypt a GRE tunnel to provide multiprotocol support and reduced overhead? A. 3DES B. multipoint GRE C. tunnel D. transport Correct Answer: D

Which statement is true about an IPsec/GRE tunnel?

Which statement is true about an IPsec/GRE tunnel? A. The GRE tunnel source and destination addresses are specified within the IPsec transform set. B. An IPsec/GRE tunnel must use IPsec

Which three features are benefits of using GRE tunnels in conjunction with IPsec for building site-to-site VPNs?

Which three features are benefits of using GRE tunnels in conjunction with IPsec for building site-to-site VPNs? (Choose three.) A. allows dynamic routing over the tunnel B. supports multi-protocol (non-IP)

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to switch technology?

The implementations group has been using the test bed to do a ,,proof-of-concept that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a ‘proof-of-concept’. After several changes to the network addressing, routing schemes, a trouble ticket has been opened indicating that

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’. After several changes to the network addressing, routing schemes, a trouble ticket has been opened indicating that

What is the solution to fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’. After several changes to the network addressing, routing schemes, a trouble ticket has been opened indicating that

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

Which device is the fault condition located?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

The fault condition is related to which technology?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What is the solution to the fault condition?

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several

What will the debug output on the console show?

The following commands are issued on a Cisco Router: Router(configuration)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1 Router(configuration)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1 Router(configuration)#exit Router#debug ip packet 199

What level of logging is enabled on a Router where the following logs are seen?

What level of logging is enabled on a Router where the following logs are seen? %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state

Which two commands will you use to replace the existing commands?

You have the followings commands on your Cisco Router: ip ftp username admin ip ftp password backup You have been asked to switch from FTP to HTTP. Which two commands

Which two of the following options are categories of Network Maintenance tasks?

Which two of the following options are categories of Network Maintenance tasks? A. Firefighting B. Interrupt-driven C. Policy-based D. Structured Correct Answer: BD

Which layer of the OSI model does the problem most likely exist?

You enabled CDP on two Cisco Routers which are connected to each other. The Line and Protocol status for the interfaces on both routers show as UP but the routers

What statement is correct regarding the output shown in the graphic?

Refer to the shown below. %LINK-3-UPDOWN: Interface Serial0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up What statement is correct regarding the output shown

Which statement reflects what the effect is of this configuration sequence?

Refer to the configuration statements shown in the graphic above. R1(config)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1 R1(config)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1 R1(config)#end R1#debug ip packet