web analytics

Which three are components of the Cisco Unified Computing System 2104 I/O Module?

Which three are components of the Cisco Unified Computing System 2104 I/O Module? (Choose three.) A. multiplexer B. chassis management console C. chassis management switch D. finite state machine E.

Which two devices can be used to provide connectivity?

A customer wants to connect to their SAN via Fibre Channel. Which two devices can be used to provide connectivity? (Choose two.) A. Cisco Nexus 5548UP Switch B. Cisco MDS

Which three layers of the OSI model are included in the application layer of the TCP/IP model?

Which three layers of the OSI model are included in the application layer of the TCP/IP model? (Choose three.) A. 2 B. 6 C. 3 D. 7 E. 4 F.

Which two statements about configuring VLANs on the Cisco Nexus 7000 platform are true?

Which two statements about configuring VLANs on the Cisco Nexus 7000 platform are true? (Choose two.) A. Software updates are disruptive to VLANs. B. VLANs with the same number are

What two actions can be taken to enable inter-VLAN communications in the data center?

What two actions can be taken to enable inter-VLAN communications in the data center? (Choose two.) A. extend Layer 2 services to a Layer 3 capable VLAN using Layer 3

Which two statements are true regarding disruptive load balancing and regarding the configuration In this example?

Which two statements are true regarding disruptive load balancing and regarding the configuration In this example? (Choose two). A. In this scenario disruptive load balancing is disabled. B. In this

Which command should the engineer use?

An engineer created three VSANs on the Cisco MDS switch. VSAN 100 is allocated to the marketing department, VSAN 110 is allocated to the research department, and VSAN 120 is

When command set will create an access control 1st on a Cisco Nexus switch to permit only unencrypted Web traffic from any source to destination host 10.10.1.110?

When command set will create an access control 1st on a Cisco Nexus switch to permit only unencrypted Web traffic from any source to destination host 10.10.1.110? A. N5K-A(config)#access-list 101

Which two terms can take the place of the wildcard mask in an ACL?

Which two terms can take the place of the wildcard mask in an ACL? A. eq B. deny C. host D. all E. any Correct Answer: CE

Which type of media uses electromagnetic waves that are generated by lasers, is often used in campus backbones, and is capable of transmitting to a distance of 60 kilometers?

Which type of media uses electromagnetic waves that are generated by lasers, is often used in campus backbones, and is capable of transmitting to a distance of 60 kilometers? A.

Which option describes what a switch does after it items that a host has connected to a switch port?

Which option describes what a switch does after it items that a host has connected to a switch port? A. Flood the frame only on all of its trunk ports.

Which command should be used to obtain the switch serial number?

A network engineer wants to apply for new license key file. Which command should be used to obtain the switch serial number? A. MDS-A# show license serial-number B. MDS- A#

What are two physical components of the Cisco UCS B-Series server?

What are two physical components of the Cisco UCS B-Series server? (Choose two.) A. mezzanine slots B. power supplies (maximum of two) C. lockable front door D. redundant hot swappable

Which I/O technology can satisfy this need?

A network design team has decided to use a standard protocol to consolidate the Ethernet and San data using the existing Nexus switches. Which I/O technology can satisfy this need?

Which two options explain why this is happening?

An engineer implemented a new VSAN and examined the F-mode trunks connecting an upstream switch. The engineer noticed that the new VSAN is stuck in initializing. Which two options explain

What native Fibre Channel technology facilitates connecting multiple Fibre devices behind a single FC address?

What native Fibre Channel technology facilitates connecting multiple Fibre devices behind a single FC address? A. Fiber Channel over Ethernet B. N-Port Virtualization C. Fibre Channel Arbitrated Loop D. N-Port

Which two features must be licensed on a Cisco Nexus 7000 Switch?

Which two features must be licensed on a Cisco Nexus 7000 Switch? (Choose two) A. Virtual Port Channel B. Layer 3 C. Virtual Device Contexts D. iSCSI E. Fibre Channel

Which command will resolve this issue?

A SAN administrator recently added a new zone to the VSAN 2 zone set named zone set2, but the server is still unable to access the shared storage. Which command

Which two options are file-based storage protocols?

Which two options are file-based storage protocols? (Choose two.) A. Telnet B. CIFS C. Fibre Channel D. NFS E. iSCSI Correct Answer: BD

Which two options are multicast addresses?

Which two options are multicast addresses? (Choose two.) A. FD00::2 B. 192.168.2.2 C. FF05::2 D. 226.10.10.10 E. 240.1.0.1 Correct Answer: CD

What layer of the OSI Model provides the logical addressing that routers use for path determination?

What layer of the OSI Model provides the logical addressing that routers use for path determination? A. transport B. network C. application D. presentation Correct Answer: B

Which situation will cause a switch to flood traffic out all of the ports on the switch?

Which situation will cause a switch to flood traffic out all of the ports on the switch? A. The switch receives a destination MAC address of 0000.0000.0000 B. The switch

What two technologies can be used to connect to storage arrays on a converged Ethernet IP network?

What two technologies can be used to connect to storage arrays on a converged Ethernet IP network? (Choose two.) A. FCoE B. Fiber Channel C. iSCSI D. InfinBand E. FabricPath

What is the maximum distance that is supported by Cisco passive Twinax cables?

What is the maximum distance that is supported by Cisco passive Twinax cables? A. 5m B. 3m C. 4m D. 10m Correct Answer: A

Which three are reasons for this proposal?

A network engineer proposes that old hubs be replaced by new Layer 2 switches in the company network. Which three are reasons for this proposal? (Choose three.) A. Each port

Which table in a switch must be populated with forwarding information as to reduce Layer 2 flooding in the network?

Which table in a switch must be populated with forwarding information as to reduce Layer 2 flooding in the network? A. MAC table B. forwarding table C. ARP table D.

What are three features of the IPv6 protocol?

What are three features of the IPv6 protocol? (Choose three.) A. optional IPsec B. autoconfiguration C. no broadcasts D. complicated header E. plug-and-play F. checksums Correct Answer: BCE

Which address and subnet combination is valid for a host assignment?

Which address and subnet combination is valid for a host assignment? A. 172.23.175.210/15 B. 10.100.74.127/25 C. 192.168.73.223/29 D. 10.230.33.15/28 Correct Answer: B

What is the minimum number of fabric modules that should be installed in the Cisco Ne*js 7000 chassis for N 1 redundancy using Ml-Series line card?

What is the minimum number of fabric modules that should be installed in the Cisco Ne*js 7000 chassis for N 1 redundancy using Ml-Series line card? A. 3 B. 4

What is the minimum number of disks that are needed in RAID 1?

What is the minimum number of disks that are needed in RAID 1? A. 4 disks B. 2 disks C. 8 disks D. 16 disks Correct Answer: B

Which mode can this list be configured?

To improve security, a network engineer needs to configure an access list on a router. In which mode can this list be configured? A. global configuration B. user access C.

Which device does a network engineer use to break the network environment into smaller collision domains?

Which device does a network engineer use to break the network environment into smaller collision domains? A. switch B. router C. hub D. repeater E. CSU/DSU Correct Answer: A

Which technology meets this requirement on a single Cisco MDS9148 switch?

A customer requires two separate physical pathways between multiple initiators and multiple targets. Which technology meets this requirement on a single Cisco MDS9148 switch? A. zoning B. port security C.

Which command should be used to determine which hosts are Fibre Channel targets?

Which command should be used to determine which hosts are Fibre Channel targets? A. MDS-A# show host database B. MDS-A# show flogi database C. MDS-A# show fens database D. MDS-A#

Which two hosts are part of subnet 172.16.160.0/20?

Which two hosts are part of subnet 172.16.160.0/20? (Choose two.) A. 172.16.168.0 B. 172.16.176.1 C. 172.16.160.255 D. 172.16.160.0 E. 172.16.176.255 Correct Answer: AD

Which layer of the OSI Model is TCP traffic encapsulated?

At which layer of the OSI Model is TCP traffic encapsulated? A. transport B. data-link C. presentation D. application Correct Answer: A

Which two commands should be used to retain the configuration after a reboot?

An engineer must copy a new configuration to a Cisco Nexus 7010 Switch from a TFTP server. Which two commands should be used to retain the configuration after a reboot?

Which layer of the OSI Model is TCP traffic encapsulated?

At which layer of the OSI Model is TCP traffic encapsulated? A. transport B. data-link C. application D. presentation Correct Answer: A

Which command returns the needed information?

An administrator connected a new server to a Cisco MDS 9222i on Port FCL/20, but did not capture the world wide node name of the host bus adapter Which command

Which command set creates an access control list on a Cisco Nexus switch to deny only FTP traffic from any source to destination host 10.10.10.10?

Which command set creates an access control list on a Cisco Nexus switch to deny only FTP traffic from any source to destination host 10.10.10.10? A. N5K-A(config)# Ip access-list 101

Which two options are benefits of deploying FCoE beyond the access layer?

Which two options are benefits of deploying FCoE beyond the access layer? A. higher throughput compared to native Fibre Channel switches. B. FCoE cannot be deployed beyond the access layer.

Which design is this network using?

A network uses on pair of Layer 3 switches for core and distribution purposes. Which design is this network using? A. collapsed core B. collapsed distribution C. collapsed Layer 3

Which address type is used in IPv4 but is not used in IPv6?

Which address type is used in IPv4 but is not used in IPv6? A. multicast B. broadcast C. anycast D. unicast Correct Answer: B

Which command shows the MAC address, physical interfaced, VLAN and IP address of a server on a Cisco Nexus switch?

A network engineer is verifying Layer 2 connectivity of a server to a Cisco Nexus switch by checking the Address Resolution table statistics. Which command shows the MAC address, physical

Which statement is true regarding FIP in FCoE enabled Storage Area Networks?

Which statement is true regarding FIP in FCoE enabled Storage Area Networks?. A. It discovers and initializes converged network capable devices connected to an Ethernet cloud. B. it uses a

Which two statements describe characteristics of IPv6 unicast addressing?

Which two statements describe characteristics of IPv6 unicast addressing? (Choose two.) A. Global addresses start with 2000::/3. B. Link-local addresses start with FE00:/12. C. Link-local addresses start with FF00::/10. D.

Which address is valid in the data link layer of the OSI reference model?

Which address is valid in the data link layer of the OSI reference model? A. 192.168.20.1 B. 09-1B-02-1C-87 C. 07-AB-02-1F-35-C8 D. 172.16.10.12 Correct Answer: C

What describes how the 802.1Q protocol lactates the transmission of multiple Layer 2 networks on a single link?

What describes how the 802.1Q protocol lactates the transmission of multiple Layer 2 networks on a single link? A. adds 802.1Q tag information between the source MAC address and the

What are two valid reasons for adopting IPv6 over IPv4?

The network administrator has been asked to give reasons for moving from IPv4 to IPv6. What are two valid reasons for adopting IPv6 over IPv4? (Choose two.) A. no broadcast

Which two items can be configured during this setup process?

An engineer is configuring a new MDS switch. The switch is powered on, the customer connects to the console, and the initial setup script is started. Which two items can