Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on Switch1 to achieve the following results on port fa0/1?
When a device is connected, the port transitions immediately to a forwarding state.
The interface should not send or receive BPDUs.
If a BPDU is received, it continues operating normally.
A. Switch1(config)# spanning-tree portfast bpdufilter default Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast Most Voted
B. Switch1(config)# spanning-tree portfast bpduguard default Switch 1 (config)# interface f0/1 Switch1 (config-if)# spanning-tree portfast
C. Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast
D. Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast Switch1 (config-if)# spanning-tree bpduguard enable
Correct Answer: A